The Maritime Safety Committee
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Maritime Safety Committee - MSC/Circular.1009 – Amendments to the Revised Standards for the Design, Testing and Locating of Devices to Prevent the Passage of Flame into Cargo Tanks in Tankers (MSC/Circular.677) – (Adopted on 8 June 2001) - The Maritime Safety Committee

The Maritime Safety Committee

Note The amendments detailed in this Circular have been consolidated into MSC/Circ.677.

  1 The Maritime Safety Committee, at its seventy-fourth session (28 May to 8 June 2001), noting that ISO standard 15364 "Ships and marine technology - Pressure/vacuum valves for cargo tanks" was completed, approved amendments to paragraph 1.2.4 of the Revised standards for design, testing and locating of devices to prevent the passage of flame into cargo tanks in tankers (MSC/Circ.677), as follows:

  • "1.2.4 Devices should be tested and located in accordance with these standards. In addition to these standards, pressure/vacuum valves should comply with ISO standard 15364:2000 "Ships and marine technology - Pressure/vacuum valves for cargo tanks".

  2 Member Governments are invited to apply the amendments to the Revised standards, in conjunction with regulation II-2/4 footnote of the 1974 SOLAS Convention, as amended, for devices installed on or after 1 July 2002.

  3 Member Governments are also invited to bring the annexed amendments to the Revised Standards to the attention of ship designers, ship owners and other parties involved in the design, construction and operation of tankers.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.