Appendix 1 - The Methodology for the Minimum Power Lines Assessment
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Marine Environment Protection Committee - MEPC.1/Circular.850 Rev.3 - Guidelines for Determining Minimum Propulsion Power to Maintain the Manoeuvrability of Ships in Adverse Conditions - (7 July 2021) - Appendix 1 - The Methodology for the Minimum Power Lines Assessment

Appendix 1 - The Methodology for the Minimum Power Lines Assessment

 1 The minimum power line values of total installed MCR, in kW, for different types of ships should be calculated as follows:

  • where:

  • DWT is the deadweight of the ship in metric tons; and

    a and b are the parameters given in table 1 for tankers, bulk carriers and combination carriers.

Table 1: Parameters a and b for determination of the minimum power line values for the different ship types

Ship type a b
Bulk carrier which DWT is less than 145,000 0.0763 3374.3
Bulk carrier which DWT is 145,000 and over 0.0490 7329.0
Tanker 0.0652 5960.2
Combination carrier see tanker above

 2 The total installed MCR of all main propulsion engines should not be less than the minimum power line value, where MCR is the value specified on the EIAPP Certificate.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.